Field" Calibration By Maximum And Middle Diameter - Re US3 User Manual

Re
S.p.A.

"Field" calibration by maximum and middle diameter

Where must be done
It is a field calibration. Sensor is mechanically installed in its own definitive position.
How calibrate
Enter the programming menu (see on page 10);
Press ENTER to position on function F2;
Carry out function F2 for field calibration as described on page 15;
Position on function F3 and carry out as described on page 16.
Position on function F10 and keep pressed ENTER key to save and exit.
Advantages
Allows you to set the precise value the output adopts at the intermediate diameter.
Disadvantages
It is necessary to use a voltmeter.
It is necessary to know maximum and middle diameter.
Rev.12/04/11
US3
12/23