Ispring DF1 Series User Manual

DF1/DF2 Series Faucet MountWater Filter User's Manual
Product Benefits
•
Removes chlorine, chloramine, germs, cysts, lead, mercury, lindane, atrazine, VOCs & many other
contaminants.
•
Improves the taste of tap water.
•
Fast flow rate of up to 1.5 GPM with long-lasting filter life up to 500 Gallon.
Precautions
1. Install with normal or lower water pressure (below 70psi).
2. Install using standard tap water sources.
3. Maximum temperature: 100 °F; Minimum temperature: 40 °F
Installation
Installation varies depending on the bath or kitchen faucet you are installing the filter on.
Metal adapter
Universal adapter
1. Included with the package are a metal adapter with 2 male ends, a universal adapter and sealing
washers.
2. Remove the aerator from the faucet if it has one. For faucets with external threads, place the
sealing washer into the metal connector of the faucet filter and connect to the faucet. If your faucet
has fewer threads, add the sealing washer from the metal adapter into the connector as well for a
better seal. For faucets with internal threads, use the metal adapter to connect the faucet filter to
the faucet. For faucets without aerators, attach the universal adapter to the outside of the faucet.
3. Turn on the faucet. Turn the diverter handle in line with the connector for regular tap water.
4. Turn the diverter handle perpendicular to the connector for filtered water. To flush out the loose
carbon, keep the faucet on for a couple of minutes until water runs clear.
Usage Recommendations
1.
Let the water run for 10 seconds before use every day.
2. If the product has not been used for more than two days, let the water run for one minute before use.
3. Do not use the product when the filter is unscrewed
4. The service life of the product may vary according to water quality, pressure, and usage frequency. For
details, pleaserefer to "Filter Replacement".
5. For areas with higher water pressure, turn down the tap water valve before use.
1 2
1
3 4