MB QUART MBQX-POD-1 Installation Manual page 10

FRONT SPEAKER INSTALLATION (Continued)
This section continues front speaker installation focusing on the driver's side. Final driver's side panel
installation will occur AFTER the audio system initial testing is validated and complete.
Depress
Tabs
1
Remove switches on lower left
of original driver's side dash
panel by depressing the tabs
on the top and bottom of the
back of switch.
4
Ensure the clip retainers and
washers from the original dash
panel have been reinstalled
correctly before proceeding.
DOUBLE CHECK INSTALLATION STEPS TO THIS POINT
Take a few minutes to double check all of the installation steps to this point ensuring the amplifiers,
speakers and wiring has all been connected as shown in these instructions.
PROCEED TO THE NEXT PAGES TO CONFIRM SETTINGS AND BEGIN TESTING THE SYSTEM.
2
Replace
Switches
Replace switches in the same
locations within the new MB
Quart driver's side dash panel
by simply pushing each into its
mounting opening.
5
Connect driver side speaker
to your installed speaker wire.
Crimp connectors are needed
to mate with speaker terminals.
10
8mm
Screws
3
If the vehicle has the Smart-
Lok differential control module,
attach to the underside of
the new dash panel with the
original four 8mm screws.
6
Set panel temporarily in place
without attaching any hardware
or clips. Do not yet plug in
switches in case amplifier
adjustments are needed.