Table of Contents
Advertisement
VEHICLE REASSEMBLY
As you begin reassembly, take the time to ensure no fastener, screw or clip is excluded. Review any prior
disassembly steps to ensure you don't miss any hardware during reassembly.
1
Plug in all switch wiring on
back of the driver side front
speaker panel. Test switch
functions to ensure they are
correctly connected.
3
Secure the front speaker panel by reinstalling all the remaining clips and T-30 hardware in the same
locations removed during the disassembly process. Do not forget about reinstalling the additional
hidden push pin under the driver's side dash, between the steering wheel and console, just forward of
the tubular chassis support.
4
Reinstall the gauge panel with the two T-30 screws and two 10mm nuts. With this step completed, the
driver side front speaker panel installation should be complete.
5
Double-check the wiring from the bus bar and ensure the nuts on the connections are tight. Ensure
all of your wiring is secured to factory wiring with zip ties. Do not zip tie any part of the power/speaker
wiring or the RCA audio cable to any heat or moisture sources, or to any moving parts.
6
Reinstall lower center console cover with two T-30 screws and two push pins. Refer to the top of page
6 for disassembly steps and simply do these in reverse.
7
Reinstall four T-30 screws in the center dash. Two forward of the gear selector and two additional
in the upper center dash forward of the fuse panel. Once complete, reinstall the upper center dash
access cover behind the upper dash pocket area housing. Refer to page 4 for disassembly steps and
simply do these in reverse.
8
Reinstall driver and passenger center console side panels by gently snapping back into place. Ensure
no wiring is exposed or pinched. Refer to page 4 for disassembly steps and simply do these in reverse.
9
Reinstall driver and passenger seats with the original 18mm bolts in the rear and 13mm bolts/nuts in
the front. Refer to page 3 for disassembly steps and simply do these in reverse.
2
Place driver side speaker panel
into its final position*. Check fit
so that all open hardware and
clip holes are aligned properly.
14
*AFTERMARKET ROLL CAGES
Although MB Quart front speakers
come pre-installed in the Can-Am
replacement panels, they may
require removal from the panel to
fit low-slung aftermarket roll cages
that fit close to the hood area.
In these cases where fit is tight or
would damage the speaker due to
the roll cage position, remove the
speaker from the panel first, install
the panel in the vehicle, then
connect and install the speaker
into the panel.
Advertisement
Table of Contents
