Table of Contents
Advertisement
CONNECT AND ROUTE WIRING
This section covers the recommendation of connecting your power, ground and ignition/accessory wiring to
the bus bar in the passenger side center console and routing that wiring to the dash area.
Ground
Battery +12V
Ignition +12V
1
Identify bus bar in passenger
side center console. Top is
chassis ground, middle is
constant +12v power (battery)
and bottom is +12v ignition.
Zip Tie
4
Next, begin to zip tie the wiring
you've connected to existing
factory wiring and begin routing
everything forward. Stop every
8-10" to add another zip tie.
7
Route your wiring up to
steering column support bar
area. This allows space to work
for likely amplifier and source
unit locations.
2
Connect your Ground, Battery
and Ignition wires to the bus
bar locations. Ensure there is
a fuse holder on the main +12
volt battery connection.
5
Continue routing your wiring
forward along the passenger
side console as indicated by
the arrow and zip tie to factory
wiring.
8
Crimp or solder connections to
the source unit's power wiring
connector. Extend the source
unit's remote turn-on wire to
the amplifier mounting area.
7
3
Remove the fuse from the main
fuse holder you've installed
so the power wiring is not
live while routing through the
vehicle.
6
Route your wiring upward
behind the center dash as
indicated where the panel was
removed. Secure with zip ties
to factory wiring.
9
Use high quality electrical
tape or a lighter/heat gun to
heat shrink any connections.
This ensures no moisture will
penetrate the wiring
Advertisement
Table of Contents
