Table of Contents
Advertisement
VEHICLE DISASSEMBLY
Removal of the center console inner cover facilitates routing wiring from the recommended bus bar location
into the dash area where the amplifier and source unit are likely to be installed
INNER COVER OF CENTER CONSOLE
1
Driver's Side View
Prepare to remove forward
inner cover of the center
console. Note - some modified
vehicles may have aftermarket
console electronics present.
BEFORE PROCEEDING - ITEMS YOU NEED:
To install a complete audio system, you need to have the following items not included in this kit. If you
already have an audio system installed and are simply adding the MBQX-POD-1 kit, you may only need
some of the items depending on whether or not you have existing amplifier(s) and other components.
1
SOURCE UNIT - MB Quart recommends using a source unit that is "mechless" with no moving
internal parts like traditional CD/DVD players commonly have. In addition since this will be used in an
off-road and outdoor environment, a source unit with IPX (water and dust intrusion) rating is highly
recommended. Finally, the source unit should have a remote turn-on output to activate the amplifier
when the source unit is on. Check out the MBQX-RAD-1 specifically for Can-Am X3 vehicles.
2
SOURCE UNIT POWER & GROUND WIRING - Whichever source unit is chosen, it will require +12
volt power, chassis ground and likely +12 volt accessory connections. You'll also need a remote
turn-on wire and RCA audio cable to connect to the amplifier. The recommended power wiring
size depends on the source unit, but #16 AWG copper wiring is common. MB Quart recommends
connecting this power/ground/accessory wiring at the Can-Am X3's accessory bus bar located in the
center console on the passenger side. This manual shows that connection point. Crimp or solder/tape
connections at the source unit.
3
AMPLIFIER POWER & GROUND WIRING - The MB Quart NA2-400.2 amplifier included in this kit
requires a minimum of #10 AWG copper wiring (#8 AWG copper wire is recommended) and a 30
ampere fuse at the point of connection for power. MB Quart recommends connecting this power wiring
at the Can-Am X3's accessory bus bar located in the center console on the passenger side. This
manual shows that connection point and recommended wire routing paths. Use of "CCA" (Copper-Clad
Aluminum) power and ground wiring is strongly discouraged.
4
SPEAKER WIRING - Each speaker panel will require wiring long enough to reach the amplifier's
location. MB Quart recommends a minimum of #16 AWG copper speaker wiring in this application.
You'll also need crimp terminals to connect the wiring to the speakers.
5
ZIP TIES - The use of zip ties to safely and securely tie down wires routed throughout the vehicle is
strongly encouraged. Zip tie your audio system wiring to existing vehicle wiring to help keep wiring
from wire movement and wear during the life of the audio system. Avoid wiring paths near sources of
heat or moving parts.
2
Remove two T-30 screws
on the lower front of center
console.
DISASSEMBLY IS COMPLETE!
6
3
Finally, remove two push pins
on passenger's side of cover
panel.
Advertisement
Table of Contents
