Hunter XC Hybrid Owner's Manual And Installation Instructions page 21

POLE MOUNT INSTRUCTIONS
③ • Route all wires up the pole
until at least 12" (30 cm) of
wire extends out of the top�
12"
(30 cm)
④ • Remove the door and bottom facepack
cover from the XC Hybrid controller�
• Place the controller on top of the
mounting plate�
• Remove all four knockouts�
• Insert four carriage bolts into the bottom
holes located underneath the controller
base� Then tighten with four nuts until the
controller does not twist and cannot be
pulled off the mounting plate�
• Replace the facepack cover and the door to
the controller�
NOTE: Make sure that
12" (30 cm) of wires
are now inside the
controller and cannot
slip back down into
the column�
19