Advanced Features; Programmable Sensor Override; Test Program Of All Stations - Hunter XC Hybrid Owner's Manual And Installation Instructions

ADVANCED FEATURES

Programmable Sensor Override

The XC Hybrid allows the user to program the controller so
that the sensor disables watering on only desired stations� For
example, patio gardens that have pots under overhangs and
roofs may not receive water when it rains and will continue to
need to be watered during periods of rain�
To program sensor override:
1� Turn the dial to the RUN position�
2� Press and hold the button down while turning
the dial to START TIMES position�
3� Release the button� At this point, the
display will show the station number, ON,
and the icon, will be flashing�
4� Press the or button to enable or
disable the sensor for the station shown�
ON = Sensor enabled (will suspend irrigation)
OFF = Sensor disabled (will allow watering)
5� Use the or buttons to scroll to the
next station that you would like to
program the sensor override�
NOTE: The controller default is for the sensor to disable
watering on all zones when rain occurs.
When the XC Hybrid receives an input from
the sensor to disable watering, the display
will indicate those stations that have been
programmed to override the sensor�
16
A station that is running in the sensor override mode will flash
the and icons alternately�

Test Program of All Stations

The XC Hybrid allows the user a simplified method for running
a test program� This feature will operate each station in
numerical sequence, from the lowest to the highest�
1� With the dial in the RUN position, press and hold the
RUN
button� The station number will be displayed and the time
will be flashing�
2� Use the
minutes� The run time needs to be entered only once�
3� After a 2-second pause, the test program will start�
Sensor Enable
Sensor Disabled
or buttons to set the run time from 1 to 15