Medisana AM 880 Instruction Manual page 25

Abdominal muscle stimulation device
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 19
WARNING - BATTERY SAFETY INFORMATION
• Do not disassemble batteries!
• Clean the battery and device contacts if necessary before putting
in the batteries!
• Remove discharged batteries from the device immediately!
• Increased risk of leakage, avoid contact with skin, eyes and
mucous membranes! If battery acid comes in contact with any of
these parts, rinse the affected area with copious amounts of fresh
water and seek medical attention immediately!
• If a battery has been swallowed seek medical attention imme-
diately!
• Replace all of the batteries simultaneously!
• Only replace with batteries of the same type, never use different
types of batteries together or used batteries with new ones!
• Keep the battery compartment well sealed!
• Remove the batteries from the device if it is not going to be
used for an extended period!
• Keep batteries out of children's reach!
• Do not attempt to recharge these batteries! Danger of explosion!
• Do not short circuit! Danger of explosion!
• Do not throw into a fire! Danger of explosion!
• Keep unused batteries in their packaging away from metal objects
in order to prevent short circuiting!
3.2
Connect the plug
Prepare the
control unit in that way into the holder, that it is
device
safely connected by the magnets
belt and make sure, the 4 electrodes
direct contact with your skin in the abdominal re-
gion. You may use the extension belt
the device properly.
3.3
Switch on the device by pressing the on-/off-button
Operating
A beep sound will be emitted by the device. Select a program (A to F) with
the program selection button
level 0 to 50) with the two buttons for intensity adjustment
start to countdown the time until 0 is reached. The device will be switched
off automatically when the time has run up.
If you want to change the program during use, press the program selection
button
be set to the old intensity level again after the new program is running. You
may stop this process by pressing the arrow-down-button
to the device and place the
3
again - this will cause an automatic reset of the intensity to 0. It will
5
. Put on the
6
are in
9
to put on
8
. You may now adjust the intensity (from
5
3 Operating
.
1
. The timer will
4
.
4
GB
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

88322

Table of Contents