If detecting no SD card during the operation, it will prompt "SD Card
does not exist!"; if any other wrong happened, it will pop up the
relevant prompt, please check it according to this prompt.
3.
BRIGHTNESS
Set system
brightness. Scroll left to decrease the brightness, or scroll right to
increase the brightness.
4.
R/G/B GAIN
Set system
adjust the gain values. Scroll left to decrease the gain, or scroll right
to increase the gain.
5.
FIRMWARE UPDATE
Select system
UPDATE item to upgrade the firmware, it will prompt as shown in
Figure 5.2-14:
Figure 5.2-14 FIRMWARE UPDATE
Scroll right to select OK command, and press the joystick straight
down to confirm the selection. It will update the firmware from the SD
card.
6.
FACTORY RESET
Select system
CALIBRATION
CALIBRATION
FIRMWARE UPDATE EXECUTE FIRMWARE
FACTORY RESET
BRIGHTNESS item to adjust the
R-GAIN/G-GAIN/B-GAIN item to
EXECUTE FACTORY RESET
37
Monitor Settings