Unpack and Installation
Confirm all the items listed on the packing list have been
received.
Remove all the packing material including electrostatic-resistant
packing.
Retain these packing materials for future use.
2. Connect required cables for signal input and output.
3. Connect the 11~17VDC power source through DC IN interface
or powered by battery.
4. As a final step, turn on the device by toggling the power
switch located on the rear of the unit.
Install Battery:
Only support SONY NP-F series currently. Please take note of the battery
installation direction according to the "NP-F" icon near the slot when
mounting the battery. The icons are as shown in the following illustration,
slide the battery down into the slot until heard a click.
Figure 3-1 Battery Installation
8