Hitachi S10 Series Manual page 5

*5 When setting up communication between an External Device and the RS-232C/422/485 interface
module, use the IPC (RS-232C) or PS5000 (RS-422/485) cable diagrams. However, when using
PFXZPBMPR42P2 in a RS-422/485 (4-wire) configuration with no flow control, connect 7.RTS+
and 8.CTS+, and connect 6.RTS- and 9.CTS-.
When using RS-422/485 communication with External Devices, you may need to reduce the
transmission speed and increase the TX Wait time.
*6 To use RS-422/485 communication on the RS-232C/422/485 interface module, the DIP Switch
setting is required. Please refer to "Knowledge Base" (FAQs) on the support site. (http://www.pro-
face.com/trans/en/manual/1001.html)
PFXZPBMPR42P2, RS422/485 change method
PFXZPBMPR42P2 termination resistor setting
PFXZPBMPR44P2, RS422/485 change method
PFXZPBMPR44P2 termination resistor setting
*7 Set up the SIO type with the DIP Switch. Please refer to the IPC manual for details of DIP Switch.
The BOX Atom has not a switch to set the RS-232C, RS-422/485 mode. Use the BIOS for the
setting.
*8 For the connection with the External Device, on the user-created cable read as if the connector on
the Display-side is a M12 A-coding 8 pin socket. The pin assignment is the same as described in
the cable diagram. For the M12 A-coding connector, use PFXZPSCNM122.
DIP Switch settings (PL3000 / PS3000 Series)
RS-232C
DIP Switch
1
2
3
4
5
6
7
8
9
10
*1 When using PS-3450A, PS-3451A, PS3000-BA and PS3001-BD, turn ON the set value.
GP-Pro EX Device/PLC Connection Manual
Settings
Setting
*1
OFF Reserved (always OFF)
OFF
SIO type: RS-232C
OFF
OFF Output mode of SD (TXD) data: Always output
OFF Terminal resistance (220Ω) insertion to SD (TXD): None
OFF Terminal resistance (220Ω) insertion to RD (RXD): None
OFF Short-circuit of SDA (TXA) and RDA (RXA): Not available
OFF Short-circuit of SDB (TXB) and RDB (RXB): Not available
OFF
RS (RTS) Auto control mode: Disabled
OFF
5
S10 Series SIO Driver
FAQ ID
FA263858
FA263974
FA264087
FA264088
Description