IBM System Storage N Series Setup And Configuration Manual page 30

13. Use cluster show to display information about the nodes in a cluster.
14.
Related information:
26
IBM System Storage N series: Clustered Data ONTAP Switch Setup and Configuration Guide
cluster::*> network interface revert -vserver node1 -lif clus1
cluster::*> network interface show -role cluster
Logical Status
Vserver Interface Admin/Oper Address/Mask Node
------- ---------- ---------- ------------- -------- ------- ----
node1
clus1 up/up
clus2 up/up
Bringing up the first node is successful if the Is Home column is true for both
cluster interfaces and they show the correct port assignments, in this example
e1a and e2a.
This example shows that the node health for node1 and node2 in this cluster is
true :
cluster::*> cluster show
Node Health Eligibility
-------------------- ------- ------------ ------------
node1
node2
If bringing up the first node is successful, then bring up the cluster port and
revert the cluster interface on the remaining nodes by repeating Steps 10 and
11 for the other nodes.
IBM N series support website
Network Current Current Is
10.10.0.1/24 node1
10.10.0.2/24 node1
Epsilon
true true false
true true true
Port Home
e1a true
e2a true