Every 100 Hours; Checking Wheel Bolt Torque; Changing Engine Oil - Kioti DK55 Manual

10-8 DK55

CHECKING WHEEL BOLT TORQUE

(1) 137 N·m (14 kgf·m, 100 ft·lbs)
(2) 215 N·m (22 kgf·m, 160 ft·lbs)
CAUTION
To avoid personal injury:
Never operate tractor with a
loose rim, wheel, or axle.
Any time bolts and nuts are
loosened, retighten to specified
torque.
Check all bolts and nuts fre-
quently and keep them tight.
Check wheel bolts and nuts regularly
especially when new. If they are loose,
tighten them as above.

EVERY 100 HOURS

CHANGING ENGINE OIL

069OA11A
(1) Oil Inlet
(2) Dipstick
(A) Oil level is acceptable within this range
(1) Drain Plug
To avoid personal injury:
Be sure to stop the engine be-
fore changing the oil.
Allow engine to cool down suffici-
ently, oil can be hot and can burn.
1. To drain the used oil, remove the drain
plug at the bottom of the engine and
drain the oil completely into the oil pan.
All the used oil can be drained out
069OA12A
easily when the engine is still warm.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper
notch on the dipstick.
Oil
capacity
DK55
with filter
069OA13A
CAUTION
8.5 (2.2 U.S.gal.)