Kioti DK55 Manual page 63

6. Attach the red clamp to the positive
terminal of the dead battery, and at-
tach the other end to the positive cable
of the helper battery.
7. Clamp the black cable to the negative
terminal of the dead battery, and at-
tach the other end to the negative
cable of the helper battery.
8. If the helper battery is in a vehicle,
start the vehicles engine and let it run
for a few moments. Then start the
disabled tractor.
9. Disconnect the battery cables in the
exact opposite order as they were
attached.
10.Remove the damp rags and reinstall
the vent caps.
(1) Dead Battery
(2) Lay a Damp Rag Over the Vent Caps
(3) Jumper Cables (4) Helper Battery
IMPORTANT
This tractor has a 12 volt nega-
tive ground starting system.
Use only the same voltage for
jump starting the tractor.
The use of a higher voltage sys-
tem for jump starting can cause
severe damage to the tractors
electrical system.
Use only a matching voltage
source when "Jump Starting" a
dead battery.
HANDLING NEW TRACTOR 5-15
069O510A