Advertisement
resistance
Continuity
Note: When the resistance is between 50Ω and 150Ω, the buzzer
may or may not sound. When the resistance is more than 150Ω,
the buzzer will not sound.
diode
4. CONtrOlS
1.
trigger
Used to open and close jaws.
2.
function switch
Select desired function as well as to turn meter on and off.
3.
display
3¾ - digit lCd, with max. reading of 3999 and unit indication.
4.
COm terminal
Plug in terminal for black test lead.
5.
terminal
Plug in terminal for the red test lead.
6.
rANGe/
Button
(i) In voltage, current or resistance measurement function this button is used to switch between autorange mode and manual range
mode as well as to select desired manual range.
(ii) In continuity or diode test function, this rANGe/
7.
HOld Button
Used to enter/exit data Hold mode.
8.
In dc current measurements this button is used for zeroing before measurement.
In other measurements, this button can be used to enter/exit Relative mode.
9.
finger guard
10.
Jaws
Used to clamp conductor for current measurements.
Buzzer
Buzzer sounds if a button is pressed.
Before the meter turns off automatically, the meter will emit 5 short beeps, 1 minute later it will emit a long beep then turn off
automatically.
© Jack Sealey limited
button is used to switch between continuity and diode test functions.
Original Language Version
TA305 Issue 3 (3) - 12/12/18
Advertisement
