Control Panel Lock-Out Feature; The Beeping Sound - Whirlpool 9200 SERIES Use & Care Manual

Operating Instructions
Continued
Control panel lock-out feature
This feature lets you lock-out the function of the
control pads (except to cancel or pause a cycle
that is running). When the control panel is locked-
out, the dishwasher cannot be started and a
running cycle cannot be changed.
To use the lock-out feature:
1. Press and hold the OPTIONS and DELAY pad
until the CLEAN signal light flashes.
2. Release the pads. The CLEAN signal light will
stop flashing.
To cancel the lock-out teature:
1. Press and hold the OPTIONS and DELAY
the CLEAN signal light turns on and
2. Release the pad. The CLEAN signal light will
turn off.
The beeping sound
Each time a control pad is pressed, a single
"beep" sound is made. A double beep means one
of the extra features was selected (such as control
panel lock-out) or the wrong control pad was used.
To turn off the beep:
1. Press and hold the OPTIONS pad until the
CLEAN signal light flashes.
2. Release the pad. The CLEAN signal light will
turn off.
NOTE: A power failure WIII reset this feature.
You will have to redo the above steps.
To turn the beep back on:
1. press and hold the OPTIONS pad until the
CLEAN signal light turns on and stays on.
2. Release the pad. The CLEAN signal light will
turn off.