Whirlpool 8500 Series Use And Care Manual page 19

Connecting A Portable
Dishwasher
NOTE: A special adapter must be installed
on the faucet before the dishwasher can be
connected. Complete instructicns and the
adapter are packed wfth your dishwasher.
When moving your dishwasher make sure
the door is latched. Hold the dishwasher at
the top front ccmers.
Before starting
1.
2.
3.
4.
5.
6.
7.
Run water at faucet until it is hot. Turn
water off.
Pull hoses out of their storage ccmpatt-
ment on the back of the dishwasher.
NOTE: Make sure the hoses are not
kinked or twisted. Kinked hoses reduce
washing performance.
Pull down on the locking collar while
lifting the hose connector onto the faucet
adapter.
When the connector snaps into place,
release the locking collar.
Turn the hot water on slowly until it is all
the way on.
Plug in power supply cord.
See page 6 for instructions on how to
start the dishwasher.
' Hoseconl
nection
While dishwasher is running
You can draw water from the faucet while
l
Press the red button on the hose connec-
the dishwasher is connected. Do
not
draw tor to draw water from faucet. (The faucet
water while the dishwasher is filling or while
is set on hot. Adjust faucet for the water
water is being pumped out. (This helps temperature you want.)
prevent a low fill when dishwasher is filling
or mixing drain water with fresh water.)
NOTE: Turn hot water back on after you
draw water from faucet. Turn off cold water.
19