Advertisement
INSTALLATION
. Compare the alignment of the appliance to the
surrounding cupboard. The top of the appliance shoul
PART III
INSTALLATION INSTRUCTIONS
be level from side to side (see diagram below). If
INSTALLING YOUR WINE COOLER
you need to adjust the level, use the levelling feet as
1. Move the unit into its final position. (CAUTION: for safety purpose, for the KBU100 and KBU170 models, it is necessary to anchor
the appliances to the wall, please refer to the instruction on the next page.)
2. If the unit is not tilting back, minor adjustments can be made to the leveling legs.
detailed in step 2.
3. Compare the alignment of the appliance to the surrounding cupboard. The top of the appliance should be level side to side (see
diagram below).
4. If the unit now rocks from one corner to the opposite rear corner, this means that the floor is uneven. You may need to put some
. If the appliance now rocks from one corner to the
packing under the ridge to the rear of the appliance. You could use thin pieces of a solid material such as a thin board, vinyl floor tiles
or laminate.
5. You may now need to fine tune the installation by repeating steps 2, 3 and 4.
opposite rear corner, this means that the floor is uneve
6. Wipe off any dust that has accumulated during shipping and clean following the directions in Part VI ( Care & Maintenance)
7. Plug the appliance into the power point. Don't use a double adaptor or extension cord.
You may need to put some packing under the ridge to
8. It is recommended that you allow the unit to rest an hour or two before you put any wine bottles in it. This will confirm that it is
operating correctly and make the conditions appropriate for wine storage.
the rear of the appliance. You could use thin pieces of
Congratulations! You have successfully installed your wine cooler.
DOOR LOCK
solid material such as thin board, vinyl floor tiles
This unit comes with an optional key lock. The keys are located inside the plastic bag that contains the user manual. To lock the door,
simply insert the key into the lock and turn clockwise making sure the metal pin is engaged completely. Then remove the key and place it
in a secure place for safekeeping. To unlock the door, insert the key into the lock and turn counterclockwise.
or laminate.
. You may now need to fine tune the installation by
COMPRESSOR WINE REFRIGERATORS
repeating steps 2, 3 and 4.
. Wipe off any dust that has accumulated during shippi
www.kingsbottle.com (USA) ｜www.kingsbottle.com.au
and clean following the directions on page 17.
(Australia)
6
Advertisement
