Use - Ostermann e-Desk 1+2 Design And Operating Instructions

10. Set up the desk with at least two people. Grasp the table frame (not the table top) and turn the desk over. Adjust the
pre-installed sliders to the feet as required.
11. Plug the power cable into a 230 V socket.

4. Use

Make sure that there are no obstacles that prevent the table from moving up and down. Ensure that the desk top is not
touching any walls and that all cables are of the required length for each desired height change.
IMPORTANT: You must reset the electronics before use.
RESETTING: Press and hold the down key on the switch until the desk reaches its lowest height. Release the down key. Press
and hold the down key again until the LED display shows „RST" (10 seconds for non LED displays). Release the down key. Press
and hold it again until the desk descends a little, rises slightly and stops. Release the down key again. Your desk is now ready
for use. The table frame can be adjusted by pressing the key up or down until the desired height is reached.
Programming the memory function for the handset control:
Due to the automatic height adjustment, there is an increased risk of crushing when using the control element hand switch
with memory function. Therefore, make sure that there are no persons or objects in the danger area and that no one reaches
into the danger area.
Use the up/down key to obtain the desired height, then press „M" followed by a number 1-4.
ATTENTION: As soon as a preset key is pressed, the desk moves to the programmed height (see the warning above).
9. Connect the cable that runs through the leg attached to the frame end CB
(no. 3a) to the control box (no. 6). Slide the control box (no. 6) onto the frame
end CB (no. 3a). Connect the cable (no. 9) to the other leg (no. 1) and the
control box (no. 6).
Connect the power cable (no. 8) to the control unit (no. 6).
Use the self-adhesive cable clamps (no. 15) to fasten the cables so that they
do not sag.
www.ostermann.eu 7