Ostermann e-Desk 1+2 Design And Operating Instructions page 5

3.2 Assembly
1. Check all components for completeness according to the list on page 2. Slide the control box (no. 6) out of the frame end CB (no. 3a) and
put it to one side. Separate the frame end (no. 3b) from the frame end CB (no. 3a). You will find the centre rail (no. 4) inside.
4. Slide the two centre rails (no. 4) into the two frame ends
(no. 3a and 3b). Note:
a. The grooves in the centre rails (no. 4) point inwards.
b. The grooves in the centre rails (no. 4) are closer to the upper edge, as the assembly is „overhead".
2. Place one of the table legs (no. 1) in the frame end CB (no. 3a) and make sure that the arrow
is pointing upwards. Align the holes on the table leg (no. 1) with the holes on the frame end
(no. 3a). Using the internal hexagon supplied, insert four M6x14 metal threaded screws (no. 11)
through the holes in the frame end CB (no. 3a) into the table leg and tighten each screw slightly.
After all four M6x14 metal threaded screws (item 11) are in place, tighten all screws. Proceed in
the same way with the other table leg (no. 1) and the frame end (no. 3b).
3. The frame end CB (no. 3a) should be placed on the side of the desk where you want to mount
the control box (no. 6) and the switch (no. 7). Slide the side bracket (no. 5a) into the frame end
CB (no. 3a). Insert two M6x35 metal threaded screws (no. 12) through the two holes in the top
of the side bracket (no. 5a) into the frame end. Tighten each screw slightly using the internal
hexagon supplied. After inserting the two M6x35 metal threaded screws, tighten the screws. Do
the same for the other frame end/leg assembly.
www.ostermann.eu 5