Table of Contents
Advertisement
9.
Programming change from constant pressing to single pressing
Presetting the handset with memory function for e-desk:
After programming a key (1-4 for a desired height) it must be kept pressed constantly. The system then stops automatically at
the programmed height.
Reason: Safety aspect. By pressing constantly, the user retains control of the system at all times.
The function can be reprogrammed from constant pressing to single pressing as follows:
Keep the button with the down arrow on the handset pressed until the lowest position is reached. Release the button and
keep it pressed again until the LED display shows RST.
Press and hold the button labelled 1 for about 5 seconds until the RST indicator starts flashing and the display changes as
follows
10.1 = Single pressing mode (i.e., the button with the programmed height is pressed once briefly and the system then auto-
matically moves to the programmed height by itself)
10.2 = Constant pressing mode (i.e., the button with the programmed height must be kept pressed constantly to reach the
programmed height)
Then release button 1. Press button 1 again until the desired setting (10.1 or 10.2) is shown. As soon as the desired setting
appears, release button 1 again and wait about 5 seconds until the display shows RST.
To complete programming, press the button with the down arrow until the table moves down a little, then briefly up again and
finally stops. Then release the button. The new programming is now stored, and the table can be used accordingly.
10
www.ostermann.eu
Advertisement
Table of Contents
