Fan Speed - Whirlpool DH25G0 Use And Care Manual

Good air circulation is
needed for best
performance-allow at
least 12-l 8 inches (30.5 -
45.7 cm) of air space on all
sides of the dehumidifier.
Install dehumidifier on a level floor strong enough to support
the dehumidifier with a full bucket of water.
where the temperature will not fall
below 65°F (18.3"C). Lower temper-
atures will cause ice to form on coils.
When moving dehumidifier, use the grip
areas with both hands to push
dehumidifier to a new location. Do not
lift the dehumidifier with grip area. Pick
dehumidifier
UD
from the bottom to
carry.
If icing occurs, unplug dehumidifier (or
turn off) until ice melts and room
temperature rises.
EMPTY/ADJUST BUCKEI light: DRYNESS CONTROL:
If this light is on, the dehumidifier
is
not running.This
light indicates that
you need to check:
l
If the bucket is full, empty bucket
and replace.
l
If the bucket is not in position,
remove bucket and replace. Make
sure the bucket fits all the way into
the dehumidifier and the light is off
or dehumidifier will not run.
'...
'...
'...
. . . .
This controls the amount of moisture in
the room.Turn the control knob
clockwise for more drying.Turn the
control knob counterclockwise for less
drying.Turn control knob to"NORMAL"
to maintain average humidity
conditions.
NOTE:
For the first few days of use, turn
the Dryness Control clockwise to
"DRYEST"to remove extra moisture
from the furnishings as well as the
room air. :'
FAN SPEED:
Some models: this controls fan
operation. Use desired setting.
HIGH -for faster moisture removal.
LOW
- for slower moisture removal.