Whelen Engineering Company DOT3 106 Series Installation Wiring Manual page 10

BLACK wire Connect (with Set Screw Connectors) to BLACK wire on Harness Kit.
Insert other end of BLACK Harness Kit wire into Position 2
WHITE wire Connect (with Set Screw Connectors) to WHITE wire on Harness Kit
Insert other end of WHITE Harness Kit wire into Position 3
Connect pin housing to OUTLET 2
NOTE: The remaining wires are to be connected as follows. If a wire is designated for a specific lamp (ex. Driver Side Tail
Light), that wire must be connected to the existing, factory circuit for that lamp. Some vehicles provide access to specific
circuits in fuse blocks located behind the seats in the vehicle cab. If your vehicle is not equipped with this feature, these
harness wires may have to be routed back to the actual lamp and connected directly to that specific circuit.
YELLOW wire
BLUE wire
VIOLET wire
BROWN wire
GREEN wire
ORANGE wire
Passenger Side/End of cable towards Remote Head
RED wire Position A in the 3 position DEUTSCH connector
BLACK wire Position B in the 3 position DEUTSCH connector
WHITE wire Position C in the 3 position DEUTSCH connector
Connect to Strobe Light in Remote Head
YELLOW wire Position A in the 3 position DEUTSCH connector
ORANGE wire Position B in the 3 position DEUTSCH connector
BLUE wire Position C in the 3 position DEUTSCH connector
Connect to Brake, Tail-Turn Signal Light in Remote Head
GREEN wire Position A in the 3 position DEUTSCH connector
BROWN wire Position C in the 3 position DEUTSCH connector
No Connection in Remote Head
VIOLET wire Auxiliary Wire
Passenger Side/End of cable towards Power Supply
RED wire Connect (with Set Screw Connectors) to RED wire on Harness Kit
Insert other end of RED Harness Kit wire into Position 1
BLACK wire Connect (with Set Screw Connectors) to BLACK wire on Harness Kit
Insert other end of BLACK Harness Kit wire into Position 2
WHITE wire Connect (with Set Screw Connectors) to WHITE wire on Harness Kit
Insert other end of WHITE Harness Kit wire into Position 3
Connect pin housing to OUTLET 4
NOTE: The remaining wires are to be connected as follows. If a wire is designated for a specific lamp (ex. Driver Side Tail
Light), that wire must be connected to the existing, factory circuit for that lamp. Some vehicles provide access to specific
circuits in fuse blocks located behind the seats in the vehicle cab. If your vehicle is not equipped with this feature, these
harness wires may have to be routed back to the actual lamp and connected directly to that specific circuit.
YELLOW wire Passenger Side Tail Light (Positive)
BLUE wire Negative Ground
ORANGE wire Passenger Side Brake Light and Right Turn Signal Light (Positive)
BROWN wire Negative Ground
GREEN wire Back Up Light (Positive)
VIOLET wire Auxiliary Wire
Driver Side Tail Light (Positive)
Negative Ground
Driver Side Brake Light and Left Turn Signal Light (Positive)
Negative Ground
Back Up Light (Positive)
Auxiliary Wire
Page 10