Advertisement
6. MAINTENANCE
6.1.
BATTERy REMOVAL/REPLACEMENT - Refer to 4.1
6.2.
CLEANING
DO NOT use abrasive or solvent cleaners. Use a mild detergent on a soft cloth, DO NOT to put excessive pressure on the
8
display screen.
7. TROUBLEShOOTING
Problem
Display is on, but does not show image.
1) Light is dim at maximum brightness.
2) Display turns itself off.
3) Borescope will not turn on.
Parts support is available for this product. Please email sales@sealey.co.uk or telephone 01284 757500
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERy REMOVAL (See section 5.1 for removal details).
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme.
Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
Possible Causes
1) Cable connection loose.
2) Imager probe is dirty.
1) Low battery.
2) Low battery.
3) Low or dead battery.
01284 703534
sales@sealey.co.uk
Original Language Version
Likely Solutions
1) Check cable connection.
2) Clean imager probe.
1) Replace batteries.
2) Replace batteries.
3) Replace batteries
www.sealey.co.uk
VS8233A
Issue: 1
02/12/19
Advertisement
