Electric Components - Pyle Pure Clean SLPRWAS58 User Manual

Electric Components

DANGER
Risk of electric shock.
Never touch the main plug and the socket with wet hands.
Check the power cord with main Plug for damage prior to every use. Do not use the machine if the
supply cord or important parts of the machine are damaged, e.g. safety devices, high pressure hoses,
trigger gun.
All current-conducting parts in the working area must be protected against jet water.
The main plug and the coupling of an extension cable must be watertight and must never lie in water.
Moreover, the coupling may never lie on the ground. The use of cable reels that ensure that the sock-
ets are at least 60 mm above the ground is commended.
Make sure that the power cord or extension cable is not damaged by running over, pinching, dragging
or the like. Protect the power cords from heat, oil, and sharp edges.
Always switch off the main switch when leaving the appliance unattended.
WARNING
The appliance may only be connected to an electric supply that has been installed by an electrician in
accordance with IEC 60364.
The appliance may only be connected to alternate current. The voltage must correspond with the type
plate of the appliance.
For safety reasons, we recommend that you operate the appliance only via a residual current device
(max. 30mA).
An unsuitable electrical extension cable can be hazardous. Only use an electrical extension cable
which has been approved and labeled for this purpose and has an adequate cable cross-section
outdoors: 1 - 10 m: 1.5 mm 2;10 - 30 m: 2.5 mm2
Always fully unreel the extension cable from the cable drum.
Substandard electrical extension cable can be hazardous.
www.PyleUSA.com