Pyle Pure Clean SLPRWAS58 User Manual page 12

Start Up
Park the appliance on an even surface.
Insert the main plug into the socket.
Water supply
For connection values, see type plate.
ATTENTION
Impurities in the water can damage the high-pressure pump and the accessories.
This high-pressure cleaner is suited to work with the YILI suction hose with backflow vale to draw in
surface water from water butts or ponds.
Fill the suction hose with water.
Screw the suction hose into the water connection of the appliance and insert it into the water source
(e.g. rainwater drum).
Bleed the device as follows prior to operation:
• Turn on the appliance "OFF/ON"
• Unlock the lever of the trigger gun.
• Push the lever of the trigger gun, the device will switch on.
• Let the device run (max. 2 minutes) until the water exits the trigger gun without bubbles.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
Operation
ATTENTION
Dry running of more than 2 minutes leads to damage of the high-pressure pump. If the appliance does
not build up pressure within 2 minutes, switch the appliance off and proceed in accordance with the
instructions in Chapter "Troubleshooting"
www.PyleUSA.com