Overview; Gyro Compass Selected; Magnetic Compass Selected - Raytheon Anschütz Standard 22 GYRO COMPASS Operator's And Service Manual

Operator Unit 130-626.NG002
Standard 22 GYRO COMPASS
1.4.1

Overview

This page provides an overview of the connected sensors (see Figure 1-2). Depending on
the status of the device, heading information is displayed. If several sensors are
connected to the operator unit, the heading data supplied by the gyro compass
designated GYRO is displayed as selected sensor. If several gyro compasses are
connected, the one designated GYRO 1 will be displayed as selected sensor.
1.4.1.1

Gyro Compass selected

If a gyro or a transmitting heading device is selected, speed (Figure 1-2/4) and latitude
(Figure 1-2/6) are displayed next to the heading information.
Speed
The last selected mode is selected by default. The following modes are available:
• Automatic Speed "Aut Speed"
• Manual Speed "Man Speed"
• Individual Speed "Ind Speed"
To switchover to "Man Speed", see chapter 2.7.2.
For information about Individual Speed, see chapter 1.4.2.2.
Latitude
The last selected mode is selected by default. The following modes are available:
• Automatic Latitude "Aut Latitude"
• Manual Latitude "Man Latitude"
• Individual Latitude "Ind Latitude"
To switchover to "Man Latitude", see chapter 2.7.3.
For Information about Individual Latitude, see chapter 1.4.2.2.
1.4.1.2

Magnetic Compass selected

If a magnetic compass is selected, variation (Figure 1-3/1) and deviation (Figure 1-3/2)
are displayed next to the heading information.
4352.DOC010002
If a Standard 30 MF gyro compass is selected, roll and pitch are
presented numerically and graphically on the dedicated subpage.
1-6 Edition: February 2020