Cleaning And Care; Troubleshooting - AEG MOTION DBT800 Instruction Book

Cleaning and care

1. Always store iron on its heel rest.
GB
To clean exterior surfaces, use a damp
soft cloth and wipe dry. Do not use
any chemical solvents, as these will
damage the surface. Do not store the
iron with water in the tank.
Disposal
Recycle the materials with the symbol
. Put the packaging in applicable
containers to recycle it.
Help protect the environment and human
health and to recycle waste of electrical
and electronic appliances.

Troubleshooting

Problem
Soleplate is not heating even though iron is
turned on.
Iron does not produce steam.
Spray function does not work.
Steam jet and vertical steam jet function does
not work.
2. Cleaning the soleplate. Do not use
scouring pads or harsh cleaners on
the soleplate as these will damage
the surface. To remove burnt residue,
iron over a damp cloth while iron is
still hot. To clean the soleplate, simply
wipe with soft damp cloth and wipe
dry.
Do not dispose appliances marked with
the symbol with the household
waste. Return the product to your
local recycling facility or contact your
municipal office.
Possible cause
Connection problem
Temperature control is in MIN position.
Not enough water in tank.
Steam control is selected in non-steam position.
Selected temperature is lower than that
specified to use with steam.
Not enough water in tank.
Steam jet function was used very frequently
within a short period.
Iron is not hot enough.
Solution
Check main power supply cable, plug and
outlet.
Select adequate temperature.
Fill water tank (see "Getting started", no 2).
Set steam control between positions of
minimum steam and maximum steam (see
"Ironing chart").
Increase temperature to at least
Fill water tank (see "Getting started", no 2).
Put iron on horizontal position and wait
before using steam jet function.
Adjust the proper temperature to steam
ironing (up to ). Put iron in vertical
position and wait until temperature indicator
light turns off.
d
GR
NL
F
GB
.
23