Bosch SCD110 Operating Instructions Manual page 23

SCD110 Operating Instructions v2.0
8 Further Product Related Information
Please find all product related documents and user guides on our website:
https://www.bosch-connectivity.com/products/industry-4-0/sense-connect-detect/downloads/
Download the SCD Sensor App
9 Trouble Shooting
Problem
The app does not display any values
The light sensor is permanently at 0
The protective cover is damaged
None of the values are changing. Is the sensor
defect?
Connection fails
I get disconnected after a while
I used the SCD only few times but the battery is
empty.
Data subject not change without notice | Printed in Germany | September 20 | Version 1.0
Apple App Store Google Play Store
Solution
Check whether you have switched the streaming
on and activated the sensors in the app.
Check if any additional label attached to the
SCD. These can cover the light sensor.
Do not use the device.
Check whether you have switched on streaming
in the app. Check if the sensor is activated.
Make sure you get a user dialog asking for
"Pairing". Make sure you accept pairing.
This can be normal. If there is no activity in the
app for two minutes, the SCD will disconnect to
save battery.
Please ensure that you disconnect SCD after
disabling the streaming. If you leave the
streaming active. It will continue to stream data
over BLE and drain the battery.
23 | 27
BCDS/GM