Operation And Maintenance - Alpine Eco-TWIST PXX1500 Instruction Manual

Pond & waterfall pump
Table of Contents

Advertisement

OPERATION AND MAINTENANCE

WARNING:
Always unplug or disconnect all appliances in the pond from the electrical supply before installing,
repairing, maintaining or handling the equipment in the water.
To avoid shortening the life of the pump, follow these simple maintenance procedures:
-Once a week, verify that the pump performance is satisfactory. If you detect a drop in pump performance (such as
a decrease in water flow from the pump or to the waterfall) first clean the pump's pre-filter cage and tubing. If the
water flow is still not fully restored to its original performance, clean the impeller and motor casing.
-The pump impeller includes a high quality ceramic shaft that provides long-lasting, reliable performance when
properly maintained. However, extreme care should be taken when handling the shaft during maintenance. Avoid
dropping or pressing too hard on it to avoid breakage or hairline fractures, which may cause the shaft to snap while
in operation.
-This pump is suitable for use in water temperatures from 32 degrees Fahrenheit (0 degrees Celsius) to 95 degrees
Fahrenheit (35 degrees Celsius).
-To keep the pump in long lasting working conditions, always replace any worn parts.
Pump Pre-Filter Cage
Do not remove the pump's pre-filter cage while operating the pump. Failure to operate the pump without the
pre-filter cage or operating the pump with a broken cage will allow large debris to enter the pump causing damage
to the pump, thus voiding the warranty.
Pump Pre-Filter Cleaning
We recommend inspecting your pump on a regular basis to ensure it is functioning properly. If you notice the water
flow rate diminish, it may be due to the pump's pre-filter cage being blocked with debris. In many cases, the clogged
filter cage can be cleaned by reaching into the pond and pulling the pump out of the water to remove the debris
from the filter cage.
Important Note: Always disconnect the power before performing maintenance on the pump. Pull off any debris
stuck to the pump pre-filter cage and/or use a garden hose to spray off any debris stuck to the filter cage.
For more information about our company or products, please visit our website at www.alpine4u.com or call us (USA) 1-877-710-0162
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents