Initial Adjustments - Foley Belsaw 200 Adjustment & Operation Instructions

INItIAl ADjUstMENts

Your machine has been set at the factory, however, a slight adjustment may be necessary. You must have the
Code Key Cutter (5726011) and the Code Tracer Guide (5726013) installed to make these adjustments. These
have been installed at the factory and are recognizable by their V-shape designs. The first adjustment you
should check on your machine is the lateral adjustment. The distance between the CODE KEY CUTTER and
the CODE KEY GUIDE must be the same as the distance between the faces of the B-18 SHOULDER GAUGE.
See Figure C. THE DISTANCE BETWEEN THE CUTTER AND GUIDE, AS SHOWN AT C-1, MUST BE
THE SAME AS THE DISTANCE BETWEEN THE FACES OF THE SHOULDER GAUGE AS SHOWN AT
C-2. There is a SPECIAL SET OF ADjUSTMENT KEYS in your parts bag that you will use to set up your
machine. Notice these two keys are identical and each has a large V-shaped groove.
C-1
C-2
Figure C
SPECIAL SET OF ADjUSTMENT KEYS
CODE CUTTER CODE GUIDE
4