CHANgINg CUttErs AND gUIDEs
G-2
Figure g
First, remove the nut and the outside collar on the cutter shaft. Turn the nut counter-clockwise to remove.
Then, install the duplicating cutter as shown at G-1. Be sure the flat side of the cutter is to your right as you
face the machine.
G-2
Figure g-1
Next, change the guide (see Figure G-1). Pull out the pin, shown at G-3, to release the spring. Pull the guide
G-2 straight forward and remove the spring. In the parts bag, there is another guide for duplicating. Slip the
spring on this guide and install it the same as the other guide. Put the pin back in to hold the spring in place.
9