CLEAN THE DOOR GASKET
Clean the door gasket with a damp cloth regularly to remove
The inside of the dishwasher is self-cleaning with normal use.
If needed, clean the tub gasket with a damp cloth and use a
brush similar to the one shown below to clean the opening in
the end of the gasket.
CARE AND CLEANING
If there is an air gap installed with your dishwasher, make sure
it is clean, so the dishwasher will drain properly.
Air gap is not part of your dishwasher. Before cleaning the air
gap, first turn off the dishwasher, then lift off the cover. Remove
the plastic cap and clean with a toothpick.
PROTECT AGAINST FREEZING
Your dishwasher should be properly protected from freezing
when left in an unheated place. Have a qualified technician
perform the steps listed below in this section.
To Disconnect Service:
Turn off electrical power to the dishwasher at the supply
source by moving fuses or tripping the circuit breaker.
Turn off the water supply.
Place a pan under the inlet valve. Disconnect water line from
inlet valve and drain into pan.
Disconnect drain line from pump and drain water into pan.
To Restore Service:
Reconnect the water, drain and electrical power supply.
Turn on water and electrical power supply.
Fill both detergent cups and run dishwasher through a heated
Check connections to make sure they do not leak.