Page 3
EFD inches 16.5 69.5 14.5 46.5 EFD mm 419 1041 1765 508 508 1118 1181 1702 Service Clearance 30” STALE AIR TO OUTSIDE FRESH AIR STALE AIR STALE AIR FRESH AIR FROM OUTSIDE TO OUTSIDE FROM BUILDING TO BUILDING...
Page 5
O F F H IG H ATTENTION O F F M E D O F F L O W...
Page 7
ATTENTION Pay special attention not to damage the Contact Pins when attaching and detaching the Face Plate. (Figure B) 1.625" 0.75" 1" 1.625" 0.75" 1"...
Page 8
ATTENTION Pay special attention not to damage the Contact Pins when attaching and detaching the Face Plate. (Figure B)
Page 11
High Speed Status Lights Select Button NOTE ABOUT TIMERS • Timers mount in standard 2” x 4” electrical boxes. • Wire multiple timers individually back to the unit. • Use 3/20 low voltage wire...
Function and Controls Basic Functions Setup Speed control is obtained by powering 24V to one of Select appropriate operational speed by installing the the designated speed taps. jumper wire between one of the designated speed taps.(A jumper wire is factory installed in the low Example: speed position.) A jumper between the R terminal and the...
Both motors contain a separate ECM circuit board to allow for independent adjustment of the motors. The "adjust" The 1500I-ECM and 1500E-ECM are equiped with ECM motors that can be programmed to maintain various tap will change the airflows on all three of the speeds.
Page 24
Damage resulting from all other causes, including but not limited to: lightning, hurricane, tornado, earthquake ® or any other acts of God; improper installation, modification, alteration or misuse of the LIFEBREATH or its oper- ation in a manner contrary to the instructions accompanying the unit at the time of sale; accidental or intentional damage, neglect, improper care, or other failure by the owner to provide reasonable and necessary maintenance of the product;...
Page 27
T 1-855-247-4200 F 1-800-494-4185 info@lifebreath.com...
Need help?
Do you have a question about the 1500I-ECM and is the answer not in the manual?
Questions and answers