Replacing The Felt Wiper - TDS BN-20 Maintenance Manual

BN-20 Maintenance Guide

Replacing the Felt Wiper

The felt wiper is a component used for cleaning the print heads. When the message shown in the
figure appears on the Utility icon on the computer task tray it is time to replace the wiper with a
new one.
Note: An alarm sounds about 30 minutes after the start of the operation. Perform the opration
by following the message displayed in the Utility window.
Note: Always carefully follow the procedures in accordance with the instructions. Otherwise a
sudden movement of the machine may cause injury.
Procedure
1. Open the Utility Window.
2. In the [Replace Tools] tab, click [Replace Felt Wiper].