TDS BN-20 Maintenance Manual page 13

BN-20 Maintenance Guide
The wiper is a component used for cleaning the print heads. When the message shown in the
figure appears on the Utility icon on the computers task tray, it is time to replace the wiper with
a new one.
Note: An alarm sounds about 30 minutes after the start of the operation by following the
message displayed in the Utility window.
Note: Always carefully follow the procedures in accordance with the instructions. Otherwise a
sudden movement of the machine may cause injury.
Procedure
1. Open the Utility window.
2. In the [Replace Tools] tab, click [Replace Wiper].
Procedures for replacing the wiper are displayed. Carefully read the on-screen instructions and
start the replacement work.