Oil And Fuel Information - Troy-Bilt TB144 Operator's Manual

CAUTION:
CAUSE PRODUCT DAMAGE. Check and
maintain the proper oil level in the crank
case; it is important and cannot be
overemphasized. Check the oil before each
use and change it as needed. See Changing
the Oil.
RECOMMENDED OIL TYPE
Using the proper type and weight of oil in
the crankcase is extremely important.
Check the oil before each use and change
the oil regularly. Using incorrect or dirty oil can cause
premature engine wear and failure.
Use a high-quality SAE 30 weight oil of API (American
Petroleum Institute) service class SF, SG, SH.
ADDING OIL TO CRANKCASE: INITIAL USE
NOTE: This unit is shipped without oil in the crankcase.
In order to avoid damage to the unit, put oil in
the crankcase before attempting to start unit.
Your unit is supplied with one 3.04 fluid oz. (90 ml.)
bottle of SAE 30 SF, SG, SH oil (Fig. 5).
NOTE: Save the bottle to measure the correct amount
for future oil changes. See Changing the Oil.
NOTE: Your new 4-Cycle cultivator is shipped for
operation in conditions above 40°F (4°C). For
cold weather operation, where temperatures
fall below 40°F (4°C), use a high-quality SAE
10W30 weight oil of API (American Petroleum
Institute) service class SF, SG, SH.
1. Unscrew the oil bottle top and remove the paper seal
covering the opening. Replace the top and cut the
tip off the funnel spout (Fig. 5).
2. Place the unit on a flat level surface with the
cultivator in a horizontal position (Fig. 6).
3. Remove the oil plug / dipstick from the crankcase
(Fig. 7).
4. Pour the entire bottle of oil into the oil fill hole
(Fig. 8).
NOTE: Never add oil to the fuel or fuel tank.
5. Wipe up any oil that may have spilled and reinstall
the oil fill plug / dipstick.
The importance of checking and maintaining the proper
oil level in the crankcase cannot be overemphasized.
Check oil before each use and change as specified in
the Maintenance Schedule.
8

OIL AND FUEL INFORMATION

OVERFILLING OIL
CRANKCASE MAY
Funnel Spout
Oil Fill
Plug/Dipstick
Oil Fill
Fig. 5
Fig. 6
O-Ring
Oil Fill Plug/Dipstick
Oil Fill Hole
Fig. 7
Fig. 8