Whirlpool LE5795XP Use And Care Manual page 13

wire dlp-
holda door
1.
2
3.
lfyowcbyarbgasandhasrlullfnd
panesMtOVObOtltp0llSloSfOUOWSZ
Unplug the power supply cd or turn
ofl the electrical power.
Open lint screen lii. Remove two
screws in lint screen area.
Open top by pulling forward and up
at eadI front uxner (see view A).
Rest raised top against wall behind
dryer (top is hinged at rear).
Remove two internal screws from
front panel flanges (near top front
comers). Lift front panel slightly.
4.
5.
6.
7.
Ming off bwer clii (see vkw b).
Sbwly pull front panel forward,
disengaging panel from drum.
(Drum will
drop
slightly.)
Move front panel aside and rest edge
against side of dryer. Avoid discon-
necting wire dips (see view C) or
damaging wires.
Remove lint from area shown in 'gas
dryef illustration on page 12 with soft
brush or vacuum deaner. Avoid
damaging wires, funnel or igniter.
Reassemble in reverse order. Before
closing the top, check the following:
- Drum seal must be flared out (see
view D) and properly positiined
against panel at hack of drum.
Rotate drum oounterckckwise one
full turn to chedr drum seal.
- Belt should be centered and tight
on dryer drum.
- Wire dips which hold the door
switch wires must be anchored in
slot in top of front panel (see
view C) and along top edge of side
panel. Door wires must not touch
drum when dryer is operating.
SOS Warning, pago 12
8. Replace top panel and lint screen
screws. Top and front panels must
be securely in place before operating
dryer.
0. Reconned power and level dryer
again (if necessary).
NOTE: Call Consumer Assistance at
l-800-253-1301 for assistance or
more information.
13