Using Tumble Pressa; Using Damp Dry; Endofcycle Signal - Whirlpool LE5550XT Use And Care Manual

Operating lnstructlons
Continued
3 P
'5
/ =- \ \
Using TUMBLE PRESS"
The TUMBLE PRESS
setting removes
wrinkles from clothing that has been
packed in a suitcase or closet, and
from items not removed from the dryer
al the end of a cycle.
1.
Set the Cycle Control Knob on
TUMBLE PRESS.
2. Push the Start Button.
The bad will tumble in heated air for
10 minutes. Then the dryer will tumble
the clothes for 10 more minutes
without heat.
For best results, put only a few
ifems at a time in this cycle. As soon
as the dryer stops, put the items on
hangers or fold them.
Using DAMP DRY
Use this setting to dry damp items that
do not require an entire drying cycle,
or to dry items to damp level. (Two
examples are heavy cottons, such as
ieans, which you do not want to
become stiff, or cctton clothes which
are easier to press when damp.)
1.
Set the Cycle Control Knob on
DAMP DRY.
2. Push the Start Button.
The dryer tumbles the load with heat
for 20 minutes, then without heat for
10 minutes.
End-of-cycle signal
The dryer sounds a signal to let you
know when the cycle is finished. The
signal cannot be turned off and is not
adjustable.
The signal is helpful when you are
drying permanent press, synthetic and
other items that should be taken out as
soon as the dryer stops.