Table of Contents
Advertisement
3.5 Reinstalling Feed Auger
1. Mount and secure the right side of the drum (A) to the
mount bracket. Tighten the two 5/8 in. bolts (B) first.
NOTE:
These two bolts are shorter than the two for the left side.
2. Place the drive chain over the sprocket on the left side of
the adapter. Slide the left housing towards the drum and
mount, leaving the driveshaft exposed 13 mm (1/2 in.). Bolt
the assemblies together.
NOTE:
Use blocking on the left side of the drum if necessary.
3. Remove the block if used.
4. Rotate the drum in forward and reverse a couple of times
to ensure the drum has been correctly rebuilt before
connecting the chain to the drive assembly.
5. Align the sprocket on the shaft, and put drive sprocket (A)
into chain (B).
NOTE:
The shoulder of drive sprocket (A) faces the auger.
6. Slide the entire drum assembly back into place, and bolt C-
clamp (C) over the housing.
®
7. Apply Loctite
242 (or equivalent) to threads of the
machine screw (MD #135157) provided in the kit. Install
machine screw (E) and washer (D) (MD #180207).
214079
INSTALLATION INSTRUCTIONS
Figure 3.24: Right End of Auger
Figure 3.25: Auger Drive
Figure 3.26: Auger Drive
17
B
C
B
A
A
D
E
Revision C
Advertisement
Table of Contents
