Table of Contents
Advertisement
3.6 Adjusting Auger to Pan Clearance
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key from ignition
before leaving operator's seat for any reason.
IMPORTANT:
Maintain an appropriate distance between auger and auger pan. Too little clearance may cause tines or flighting to contact
and damage feed draper or pan when operating header at certain angles. Look for evidence of contact when greasing
adapter.
1. Extend center-link to steepest header angle (setting D), and position header 150–254 mm (6–10 in.) off the ground.
2. Lock header wings.
3. Shut down combine and remove key from ignition.
4. Ensure float lock linkage is on down stops (washer [A] and
nut [B] cannot be moved) at both locations.
5. Ensure lower end of linkage bars (A) are against studs (B) at
both ends of auger.
214079
INSTALLATION INSTRUCTIONS
Figure 3.37: Float Lock
Figure 3.38: Linkage Bars
22
A
A
B
B
Revision C
Advertisement
Table of Contents
