Table of Contents
Advertisement
3.3 Installing New Auger Drive Parts
To install the new left auger pivot (MD #279691) and endless chain (MD #220317) provided in the kit, follow these steps:
1. On new left auger pivot (MD #279691) install bolt (A),
sprocket (B), washer(s) (C), Nord-Lock washer (J), Nord-Lock
washer (D), and nut (E) retained from previous procedure.
Do not fully tighten hardware.
NOTE:
There may be more than one washer at (C).
2. Install clamp plate (H), bolts (F) and nuts (G), all retained
from previous procedure. Do not fully tighten hardware.
3. Position adjuster bracket (C) on new auger pivot, and
secure in place with bolt (A) and nut (B). All parts are
retained from previous procedure.
4. Reinstall bolts (B) and spacers (C).
5. Reinstall two nuts (A). Position the bolts in the middle of
the slot on the adjuster bracket. Hardware should be
snug only.
214079
INSTALLATION INSTRUCTIONS
A
Figure 3.17: New Auger Pivot
Figure 3.18: New Auger Pivot
Figure 3.19: New Auger Pivot
14
B
C
J
E
D
A
C
A
H
G
F
C
B
B
Revision C
Advertisement
Table of Contents
