Table of Contents
Advertisement
3.4 Modifying Gearbox Output Shaft
1. Clean the end of the output shaft (A).
2. Drill a 5/16 in. hole (A) into the end of the shaft 25 mm
(1 in.) deep (B).
3. Thread hole (A) with a 3/8-16 UNC-2B tap.
214079
INSTALLATION INSTRUCTIONS
Figure 3.22: Gearbox Output Shaft
Figure 3.23: Gearbox Output Shaft
16
A
B
A
Revision C
Advertisement
Table of Contents
