Advertisement
8.4.
ASSEMBLE THE ROOF PANEL
8.4.1.
Place both panels item 3 on your work table and join them together with the 10mm long self tapping screws.
See the pre-punched holes and both diagrams.
8.4.2.
Fit top and bottom channels item 20A to panels by firstly sliding and finally tapping into place as previously explained in 8.1.3.
Note that the smaller flange on the channels should always be adjacent to the outside face of the panel. The outside face is the top face
in both diagrams.
© Jack Sealey Limited
Original Language Version
GSS150819SDG Issue: 1 - 27/08/14
Advertisement
