Hang the hanging brackets B on the bottom of the aluminum frame, then
7
slide the brackets so they align with the A brackets. The distance between the
brackets B should be the same as the distance you used for the brackets A.
Note: Make sure that you attach the brackets B to the aluminum frame first,
then secure the brackets to the wall.
Mark the screw holes in the brackets B, then drill pilot holes through the screw
8
holes on the brackets and into the wall with a drill with an 8 mm bit.
Insert a plastic anchor into each screw hole you drilled. Make sure that the
9
anchor is flush with the wall. If needed, tap the anchors with a mallet or
hammer.
Secure the brackets B to the wall with one screw per bracket.
10
Maintaining your screen
• Use soft brush or wet cloth to clean the screen surface.
• Don't clean the screen surface with corrosive detergents. Wipe the screen
surface with a non-corrosive detergent.
Moving your screen
• Have two people move your projector screen, one on
each side.
• Make sure that the screen stays level during moving.
• Don't twist the frame.
10
www.insigniaproducts.com