Power Management; Troubleshooting - Targus Stow-N-Go User Manual

Power Management

• To extend the life of your batteries, power off the battery
with the on/off switch located on the back of the keypad
while traveling or when you're not using it.
• Battery Low Indicator: LED fl ashes
NOTE: PLEASE REPLACE THE BATTERIES WHEN THE BATTERY LOW LED
STARTS FLASHING.
• The keypad's power saving mode feature activates after
4 minutes of non-operation. To activate the keypad, press
the NumLock key.

Troubleshooting

What do I do if the keypad does not work?
• Make sure that the polarity of the batteries is correct. The
positive (+) and negative (-) ends of each battery must
match the positive (+) and negative (-) connections in the
battery housing.
• Check that the receiver's USB connector is fi rmly attached
to the USB port on your computer.
• Verify that the device drivers are installed.
• Make sure you have established a communication link.
See "Establishing a Communications Link".
Targus Wireless Stow-N-Go Calculator Keypad