Philips Sonicare FlexCare+ User Manual page 31

2 Insert a flat-head (standard) screwdriver into the slot located at
the bottom of the handle. Turn the screwdriver anticlockwise to
release the bottom cap. (Fig. 8)
3 Hold the handle upside down and push down on the shaft to
release the internal components of the handle (Fig. 9).
4 Insert the screwdriver under the circuit board, next to the battery
connections, and twist to break the connections. Remove the
circuit board and pry the battery from the plastic carrier (Fig. 10).
Guarantee and support
If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet.
Guarantee restrictions
The terms of the international guarantee do not cover the following:
- Brush heads.
- Damage caused by use of unauthorised replacement parts.
- Damage caused by misuse, abuse, neglect, alterations or unauthorised
repair.
- Normal wear and tear, including chips, scratches, abrasions,
discolouration or fading.
Frequently asked questions
This chapter lists the questions most frequently asked about the
appliance. If you cannot find the answer to your question, contact the
Consumer Care Centre in your country.
Question
Why doesn't the
Sonicare
toothbrush work?
FlexCare+_EN_A6_cs6.indd 30
Answer
You may need to recharge the Sonicare. Charge
the Sonicare for at least 24 hours.
30
ENGLISH
16/05/13 10:4