Connecting Data And Power To The Injector - Cisco AIR-PWRINJ-60RGD1 Series Installation Instructions Manual

Connecting Data and Power to the Injector

To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement 1023
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
To connect the data cables and to power up the power injector, follow these steps:
Plug a shielded outdoor rated Ethernet cable, using the factory-shipped waterproof RJ45 connector, into
Step 1
the DATA PWR OUT port on the power injector. Assembling of the waterproof RJ45 connector is shown
in Figure
Step 2 Plug the other end of the Ethernet cable into the Ethernet Port on the access point.
Note
Step 3 Plug a shielded outdoor rated Ethernet cable, using the factory-shipped waterproof RJ45 connector, into
the DATA IN port on the power injector. Assembling of the waterproof RJ45 connector is shown in
Figure
Plug the other end of the Ethernet cable into your Ethernet switch, hub, or network.
Step 4
Plug in the AC power cord. For the RGD1=, plug the AC connector into suitable a AC receptacle. For
Step 5
the RGD2 = follow local codes to terminate the three wires of the AC cable. For AC power cord and wire
sizes, see
Connect the other end of the power cord into a 100-VAC to 240-VAC power source
Step 6
Table 1 AC Power Cord and Wire Sizes
Type
RGD2=
RGD1= (for reference only)
Cisco Aironet Series Power Injectors AIR-PWRINJ-60RGD1= and AIR-PWRINJ-60RGD2= Installation Instructions
6.
For detailed information about connecting the Ethernet cable to an access point, see the
Hardware Installation Guide for that access point.
6.
Table 1.
AC Cord Sizes
6.8mm +/-0.4mm
8mm +/-0.4mm
Connecting Data and Power to the Injector
Individual AC Wire Sizes
0.75mm/3C
18AWG/x3C
11