Cisco AIR-PWRINJ-60RGD1 Series Installation Instructions Manual page 5

•
•
•
Safety Precautions
Translated versions of the following safety warnings are provided in the Safety Warnings document that
ships with the access point and is also available on Cisco.com.
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
Read the installation instructions before connecting the system to the power source. Statement 1004
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated at not greater than 20A. Statement 1005
Warning Only trained and qualified personnel should be allowed to install, replace, and service this
equipment. Statement 1030
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of: 131F (55C) Statement 1047
Cisco Aironet Series Power Injectors AIR-PWRINJ-60RGD1= and AIR-PWRINJ-60RGD2= Installation Instructions
This product is not intended to become a permanent part of the building structure.
Power supply cord must not be attached to the building surface nor run through walls, ceilings,
floors and similar openings in the building structure.
Measures must be taken to prevent physical damage to the power supply cord, including proper
routing.
Important Safety Information
5